DocumentsTable of Contents Back to Top
- DATES:
- ADDRESSES:
- Examining the AD Docket
- FOR FURTHER INFORMATION CONTACT:
- SUPPLEMENTARY INFORMATION:
- Comments Invited
- Discussion
- FAA’s Determination and Requirements of This Proposed AD
- Costs of Compliance
- Authority for This Rulemaking
- Regulatory Findings
- List of Subjects in 14 CFR Part 39
- The Proposed Amendment
- PART 39—AIRWORTHINESS DIRECTIVES
- (a) Comments Due Date
- (b) Affected ADs
- (c) Applicability
- (d) Reason
- (e) Actions and Compliance
- (f) Alternative Methods of Compliance (AMOCs)
- (g) Related Information
DATES: Back to Top
We must receive comments on this proposed AD by June 29, 2015.
ADDRESSES: Back to Top
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
- Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
- Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
- Fax: 202-493-2251.
For service information identified in this AD, contact Rolls-Royce plc, Corporate Communications, P.O. Box 31, Derby, England, DE248BJ; phone: 011-44-1332-242424; fax: 011-44-1332-249936; email: http://www.rolls-royce.com/contact/civil_team.jsp; Internet: https://www.aeromanager.com. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
Examining the AD Docket Back to Top
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-0095; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the mandatory continuing airworthiness information (MCAI), the regulatory evaluation, any comments received, and other information. The address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Back to Top
Katheryn Malatek, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7747; fax: 781-238-7199; email: [email protected].
SUPPLEMENTARY INFORMATION: Back to Top
Comments Invited Back to Top
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2015-0095; Directorate Identifier 2015-NE-01-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD.
Discussion Back to Top
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2014-0250, dated November 19, 2014 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
There were a number of pre-MOD/SB 72-7730 High Pressure Turbine (HPT) blade failures, with some occurring within a relatively short time. Engineering analysis carried out by RR on those occurrences indicates that certain pre-MOD/SB 72-7730 blades, Part Number (P/N) UL32958 and P/N UL21691 (hereafter referred to as `affected HPT blade’), with an accumulated life of 6500 flight hours (FH) since new or more, have an increased risk of in-service failure.
This condition, if not corrected, could lead to HPT blade failure, release of debris and consequent (partial or complete) loss of engine power, possibly resulting in reduced control of the aeroplane.
You may obtain further information by examining the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2015-0095.
FAA’s Determination and Requirements of This Proposed AD Back to Top
This product has been approved by the aviation authority of the United Kingdom, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require removal of the affected HPT blades.
Costs of Compliance Back to Top
We estimate that this proposed AD affects 6 engines installed on airplanes of U.S. registry. We also estimate that it would take about 4 hours per engine to comply with this proposed AD. The average labor rate is $85 per hour. Pro-rated cost of required parts is about $250,000 per engine. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $1,502,040.
Authority for This Rulemaking Back to Top
Title 49 of the United States Code specifies the FAA’s authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency’s authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings Back to Top
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a “significant regulatory action” under Executive Order 12866,
(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
List of Subjects in 14 CFR Part 39 Back to Top
- Air transportation
- Aircraft
- Aviation safety
- Incorporation by reference
- Safety
The Proposed Amendment Back to Top
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES Back to Top
1.The authority citation for part 39 continues to read as follows:
§ 39.13 [Amended]
2.The FAA amends § 39.13 by adding the following new airworthiness directive (AD):
Rolls-Royce plc: Docket No. FAA-2015-0095; Directorate Identifier 2015-NE-01-AD.
(a) Comments Due Date Back to Top
We must receive comments by June 29, 2015.
(b) Affected ADs Back to Top
None.
(c) Applicability Back to Top
This AD applies to all Rolls-Royce plc (RR) RB211-524B-02, RB211-524B2-19, RB211-524B3-02, RB211-524B4-02, RB211-524B4-D-02, RB211-524C2-19, RB211-524D4-19, RB211-524D4-39, and RB211-524D4X-19 turbofan engines with high-pressure turbine (HPT) blades, part numbers (P/Ns) UL32958 and UL21691, installed.
(d) Reason Back to Top
This AD was prompted by several failures of affected HPT blades. We are issuing this AD to prevent failure of the HPT blade, which could lead to failure of one or more engines, loss of thrust control, and damage to the airplane.
(e) Actions and Compliance Back to Top
Comply with this AD within the compliance times specified, unless already done.
After the effective date of this AD, within 2 months or before exceeding 6,500 flight hours since first installation of HPT blades, P/Ns UL32958, and UL21691, on an engine, whichever occurs later, remove all affected HPT blades from service.
(f) Alternative Methods of Compliance (AMOCs) Back to Top
The Manager, Engine Certification Office, FAA, may approve AMOCs for this AD. Use the procedures found in 14 CFR 39.19 to make your request. You may email your request to: [email protected].
(g) Related Information Back to Top
(1) For more information about this AD, contact Katheryn Malatek, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7747; fax: 781-238-7199; email: [email protected].
(2) Refer to MCAI European Aviation Safety Agency AD 2014-0250, dated November 19, 2014, for more information. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating it in Docket No. FAA-2015-0095.
Issued in Burlington, Massachusetts, on April 22, 2015.
Colleen M. D’Alessandro,
Assistant Directorate Manager, Engine & Propeller Directorate,Aircraft Certification Service.
[FR Doc. 2015-09815 Filed 4-28-15; 8:45 am]
BILLING CODE 4910-13-P